A building permit is required to install a swimming pool unless it is prefabricated and the walls are entirely above adjacent grade. Whether a permit is required or not, the installation must meet the following code requirements that are intended to provide protection against drownings and near-drownings by restricting access to swimming pools, spas and hot tubs.
- Any swimming pool not totally enclosed by a structure must be enclosed by a substantial barrier or fence at least four (4) feet in height. The maximum vertical clearance between grade and the bottom of the barrier is two (2) inches. Openings in the barrier shall not allow passage of a 4-inch diameter sphere.
- The barrier must be equipped with a self-closing and latching gate except where bordered by a wall of an adjacent structure at least four (4) feet in height. Pedestrian access gates shall open outward away from the pool and shall be self-closing and have a self-latching device.
- No swimming pool can be nearer than three (3) feet from any lot line, and no enclosing fence or wall shall be constructed nearer than three (3) feet to the outer walls of the swimming pool.
- The location of an in-ground pool is not regulated by the zoning code unless there is an overlay zone (i.e. environmental overlay) or plan district on your property. Setback and building coverage standards apply to above-ground pools.
- An electrical permit is required for the installation of in-ground swimming pools and may be required for an aboveground swimming pool.
- Any pool is required to have either a sandfiltration system or cartridge filter system. The backwash from a sandfiltration system will need to discharge to either the public sewer or to an on-site system approved by BDS, separate from the drainfield. If you have questions about filtration for your pool, please contact Environmental Soils at (503) 823-6892.
- Swimming pools must be set back from adjacent slopes.
Prior to installing a swimming pool, we recommend that you check with your homeowner's insurance company to determine what liability you may assume as a result of the installation.